ABSTRACT
Additive manufacturing (AM) based on fused-filament processes enables lightweight, customized structural components but exhibits strong anisotropy arising from filament orientation, layer stacking, porosity and interfacial bonding. This thesis develops a predictive and experimentally validated numerical framework to model the stiffness and failure of 3D-printed structures, integrating constitutive modelling, parameter identification, multiscale homogenisation and application-driven analysis. First, a comprehensive review of AM anisotropy, structural applications and kirigami-based deployable systems establishes the motivation, research questions and modelling requirements. The core of the work proposes a finite-element formulation that incorporates imported toolpaths, local material frames, orthotropic constitutive models and elastoplastic formulations, and cohesive modelling of interlayer and interfilament interfaces. A systematic calibration protocol is defined using tensile, shear, bending and cyclic tests, enabling accurate identification of elastic, plastic and fracture parameters. The model is validated on coupons and panels, capturing force-displacement behaviour and stiffness evolution with controlled uncertainty.
A multiscale module is introduced to connect micro- and mesostructural descriptors—filament architecture, porosity and interfaces—with effective orthotropic properties through representative volume elements subject to periodic conditions. This enables consistent transfer of material parameters to the macroscale and highlights the role of print orientation on stiffness degradation. Finally, the framework is applied to kirigami-based structures relevant to lightweight deployable systems in naval environments. A dedicated experimental programme (manufacturing, quality control, deployment and compression tests) and its corresponding numerical models allow assessing load capacity, hysteresis, buckling modes and degradation mechanisms. From these results, design rules and charts are derived concerning reinforcement width, print orientation, minimum fold radii and optimal infill patterns. The thesis concludes by quantifying predictive accuracy, outlining methodological and experimental contributions, and identifying limitations and avenues for future research such as high-cycle fatigue, environmental effects and extension to advanced polymer–fibre systems.
PhD Advisors:
-
- Prof. Xavier Martinez Garcia
- Dr. Francesc Turon Pujol
CANDIDATE
Montserrat Dolz Ripollés holds a BSc in Naval Systems and Technology Engineering and an MSc in Naval Architecture and Ocean Engineering from the Universitat Politècnica de Catalunya (UPC, 2021). She is currently pursuing a PhD in Structural Analysis at UPC while conducting her research at CIMNE, within the Composites and Advanced Materials for Multifunctional Structures (CAMMS) group. She is teaching at the Barcelona School of Nautical Studies, since 2022, as an Adjunct Professor. Currently her research focuses on the characterization of the mechanical performance of 3D printed composite materials through anisotropic models coupled with composite formulations such as the serial-parallel mixing theory. This research is applicable to different engineering disciplines, but especially applies to naval engineering. She is currently taking part in a European project, Fibre4Yards, which aims to provide a modular, digitized, automated and cost-effective approach to the production of FRP vessels to increase the competitiveness of European shipbuilders.